Water transfer equipment is a new type of absolutely environmentally friendly spraying technology that has been thrown away from traditional water plating and vacuum plating.
L: 240cm x W: 120cm x H: 100cm
L: 200cm x W: 110cm x H: 85cm
3 Sets, 220v, Single Phase, 50 Hz, 6000w
Water Recirculation System
Stainless Pump, 220V, Single Phase, 50 HZ, 750W
1. Master Power On/Off Switch 2. Pump On/Off Switch 3. Heating Element #1On/Off Switch 4. Heating Element #2 On/Off Switch 5. Heating Element #3 On/Off Switch 6. Timer On/Off Switch 7. Digital Thermostat X 2 PCS 8. Digital Timer with Buzzer 9. All the red and green lights needed for the switches.
L: 250cm x W: 130cm x H: 120cm
Water transfer equipment operation and processing 1. Make sure the product is clean and statically removed before water transfer. 2. The transfer water tank must be thoroughly cleaned, not floating impurities floating on the water surface, and the residual ink film floating on the water surface, the water should be light, if it is too strong, it will produce bubbles. 3. When placing the water transfer printing film, be sure to recognize the front and back sides of the film. When you are not sure about the front and back of the film, you can try it with a little water, and the sticky side should be placed on the water surface, but Be careful not to spill water on the membrane. Pay attention to the angle of the film. At the beginning, straighten the water transfer film from the side of the water transfer tank to the other side, taking care not to generate bubbles.